Roper Pumps 2AM08 - A Series Petroleum Transfer Gear Pump 1 1/4 inch Ports ++Factory NEW!++

The Roper 2AM08 Gear Pump is a positive displacement gear pump. This self-priming pump has cast iron housing, ductile iron gears and drive shafts, and steel idler shafts. The impeller is made from ductile iron and the pump has a Buna-N mechanical shaft seal. The bearings are water-resistant and can be made from bronze, iron, or carbon as needed by the buyer. The pump operates at standard motor speeds and can be either flange or foot mounted. Lubrication isn't needed as the internal bearings are lubricated by any fluid that runs through the pump. The Roper 2AM08 Gear Pump rotates clockwise, but users can reassemble it to run counter-clockwise, and the pump has bidirectional rotation. Large steel dowel pins keep the pump's faceplate, backplate, and case positively aligned.

• The Roper 2AM08 Gear Pump's ports measure 1-1/4 inch NPT by 1-1/4 inch. It can pump up to 16.3 gallons per minute and has a max PSI rate of 150. It can handle temperatures of up to 212° F (100° C). Its liquid viscosity limit is 2,200 cSt. The maximum RPM is 1,800 and the GPR is .009. Models weigh between 35 and 40 pounds.